QR Code Link to This Post
Three-year project in the making – 3rd owner (prior to me, it sat in a shed for 25+ years). Engine is a 2.5L In-line 6 Cylinder with dual carbs. Seat coverings are original.
All of the following are new:
• Clutch, pressure plate, throw out bearing
• Clutch master cylinder and slave cylinder
• Timing chain and tensioner
• Front fenders
• Rubber seals for doors, windshield, trunk hood etc.
• Dash pads and knee bolsters
• Interior door Panels, etc.
• Convertible top
• Sun visors
• Front-end parts (ball joints, tie rod ends, rack and pinion boots) and upgraded R&P mount
• Master, wheel cylinders, front brake hoses rear adjusters and front pads
• Points, condenser, plugs, cap, rotor, & spark plug wires
• Fuel sender
• The calipers have been over hauled
• Drums & rotors have been resurfaced
• Carburetors have been gone thru